top of page

YOU NEED:

 

​         A THREADING TOOL

        

 

A MICRO-BEAD

PLIERS

A Threading tool and 2 micro- beads are included in every feather extension order.

​You can also purchase additional micro- beads from our website.


Step 4.

Use the pliers to firmly crimp the bead. To ensure comfort, crimp it in a way so it will lie flat against the head. And that's it!

Step 3.

Slide your bead off of the threading wire to the hair root and hold bead in place near the scalp. Now slide your feathers through the bead.

Step 2.

Wrap the wire tool around the strand of hair.

Take the two ends of the wire and thread them through the crimp bead.

If you are not happy with the placement simply pinch the bead in the opposite direction and start again.

 

Step 1.

Decide where you would like to install your feather extension, then peel back a layer of hair to expose the roots. Gather a small strand of hair in your fingers, make sure the roots are close together.

Removal:


To remove your feather extensions, take pliers and gently squeeze the crimp bead in the opposite direction until it is approximately O-shaped. Then, remove the feathers and slide the crimp bead out. The crimp beads are designed to only be used once, but the feathers can be installed over and over.

                                     

     Each order comes with a full set of instructions.

bottom of page